EZ Rally Timer

Connect a wired PC switch to an iPhone

The co-driver’s phone (Timer) accepts switch input; the driver’s phone (Monitor) is a supporting display and cannot operate the rally. This guide covers switches powered by a USB-C iPhone. Lightning iPhones are outside its scope.

The app interface is available in Japanese and English. Screen names quoted in this guide follow the English interface.

1. Prepare the equipment

Use a switch the iPhone recognizes as a USB keyboard and that sends Enter/Return, plus a USB data cable. The switch must be able to draw power from the iPhone.

Assign Enter/Return to a single press and save the mapping on the switch itself. Some devices require a computer for this setup.

2. Connect to the iPhone

Connect the switch to the USB-C iPhone with the data cable. No switch-enabling setting is required in EZ Rally Timer.

3. Test a practice PC while stationary

Open a practice course with consecutive PCs and start PC timing. Wait at least 1 second after the start input, briefly press the switch once and release it.

Check that exactly one PC result is recorded and the sequence advances by exactly one PC. Test the actual combination of equipment you will use.

If the switch does not respond

Close Settings and NAVIGATION (the event, day and control selection screen), and bring the competition screen on the co-driver’s phone to the foreground. The driver’s phone cannot accept competition input.

Check the Enter/Return mapping and the USB data cable. Reconnect while stationary and repeat the practice test. If input remains unreliable, use taps on the co-driver’s competition screen during the rally.

Competition input is the co-driver’s responsibility. Drivers must not operate phones or switches while driving. The organizer’s regulations and official timing take precedence.

Back to EZ Rally Timer

EZ Rally Timer support